MODELLING AND EXPERIMENTAL STUDY OF TERMOELECTRIC
MODULE AS GENERATOR
Journal Name:
- Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi
Keywords (Original Language):
Author Name | University of Author | Faculty of Author |
---|---|---|
Abstract (2. Language):
In this study, mathematical model simulation was done for using Thermoelectric Module (TEM) as
Thermoelectric Generator (TEG) by Matlab/Simulink simulation program; and mathematical model and
simulation results for different temperature ranges were confirmed by experiments. Current, voltage, power, hot
side and cold side heats and temperature difference between the surfaces of module values for continuous
monitoring and registration of a special SCADA program was developed. When Matlab/Simulink simulation
results obtained from the theoretical were compared with the experimental results measured by the SCADA, the
results were as follows; system average error percentages; for current, voltage and power: 5.57%, 5.12%, 3.72%
respectively. TEG output voltage Vmax = 2.2V, output power Pmax = 6.71W and efficiency 3.4% were
obtained, when amount of waste heat sink into TEG was QH =197W and the matched load resistance was
matched to the internal resistance at the 100°C temperature difference. The results of experimental and
theoretical analysis show that TEG has a promising potential at the recovery of waste heat for low temperatures
in especially industrial and geothermal areas.
Bookmark/Search this post with
Abstract (Original Language):
Bu çalışmada, Matlab/Simulink benzetim programıyla Termoelektrik Modülün (TEM) Termoelektrik Jeneratör
(TEJ) olarak kullanılması için, matematiksel modelinin benzetimi yapılmış ve farklı iki sıcaklık aralıkları için
benzetim sonuçları deneylerle teyit edilmiştir. Modüle ait akım, gerilim, güç, sıcak yüzey ve soğuk yüzey
sıcaklıkları ve bu yüzeyler arasındaki sıcaklık farkı değerlerinin sürekli izlenmesi ve kayıt altına alınması için
özel bir SCADA programı geliştirilmiştir. Matlab/Simulink benzetimiyle elde edilen teorik sonuçlarla SCADA
sistemiyle ölçülen deneysel sonuçlar karşılaştırılmış, ortalama hata yüzdeleri; sırasıyla akım, gerilim ve güç için
%5,57, %5,12 ve %3,72 olmuştur. 100°C sıcaklık farkında, TEJ’e giren atık ısı miktarı QH =197W iken, TEJ ve
yük dirençleri birbirine eşitlendiğinde; çıkış gerilimi Vmax = 2,2V, çıkış gücü Pmax = 6,71W ve verim %3,4 elde
edilmiştir. Deney ve teorik analizin sonuçları, özellikle endüstriyel ve jeotermal alanlarda, düşük sıcaklıklar için
atık ısı geri kazanımında, TEJ’in umut verici potansiyele sahip olduğunu göstermiştir.
FULL TEXT (PDF):
- 4