Buradasınız

Anasayfa » Content

Characteristics of Some Natural Fibrous Assemblies for Efficient Oil Spill Cleanup

Journal Name:

  • International Journal of Science and Engineering Investigations

Publication Year:

  • 2013

Key Words:

Author NameUniversity of Author
Abstract (2. Language): 
Oil spill cleaning is an essential head target for all environmental concerns due to its serious results in destroying marine life and vegetation. Cleaning oil spill is done by three main procedures, namely burning, isolating and skimming and collection. There is an urgent demand to improve a cheap and more efficient methods and materials for this target. Using natural fibrous resources for sorption of these contaminations satisfy most important criteria in oil collection direction. This work was done to investigate the efficiency of four natural fibrous sorbents, namely cotton fibers, seed floss of kapok (Ceiba pentandra) and milkweed or usher (Calotropis procera) and sheep fleece for sorption of three commercial petroleum oil products. Four densities of the fibrous fillers (0.2, 0.5, 0.8 and 1.1g/cm3) as well as three temperature levels were tested on three different kinds of petroleum oils, namely diesel engine oil, hydraulic oil and diesel fuel. The scanning electron microscopy showed clearly smoothness surface for both seed floss resources and the roughness of the fleece surface which has an important role in oil sorption in the later case. The higher crystallinity investigated by the wide angle-XRD of milkweed seed floss than that for kapok reflects lower porosity in the cell wall nanostructure that offers additional mechanism for kapok to hold more oil. The cotton fibers had the highest oil retention among the species studied during the temperature range. Further, oil retention of the four fiberous assemblies decreases with increases in temperature from 25° to 60°C. Higher temperatures reduce oil viscosity, making it difficult for the oil to adhere to the sorbent material. Among the species studied, oil retention of cotton fibers was the highest (about 10 g oil oil/g of sorbent for the assembly density of 0.2 g/cm3) and gradually decreased from kapok to milkweed and finally to sheep fleece for all the four assembly density studied. In addition, within species, the lower the assembly density the higher the oil retention obtained. Further, the assembly density of 0.8 and 1.1 g/cm3 gave very low oil retention due to the shortage occurred in the capillary bulk within them. Further, within the assembly density, there is no significant difference between the oil resources determined. The clear effect is found between the assembly densities.
Bookmark/Search this post with
FULL TEXT (PDF): 
PDF icon ijsei-21613-17.pdf
  • 17
89-96
  • English

REFERENCES

References: 

[1] Wardley-Smith J (1983). The control of oil pollution. Graham and Trotman Publication, London, 285 pp.
[2] Hussein, M.1, Amer, A. A. and Sawsan, I. I. 2011. Heavy oil spill cleanup using law grade raw cotton fibers: Trial for practical application. Journal of Petroleum Technology and Alternative Fuels. 2(8): 132-140.
[3] Jordan RE, Payne JR. 1980. Fate and weathering of petroleum spills in the marine environment: A literature review and synopsis. Ann Arbor Sci. Publishers, Ann Arbor, MI, p. 174.
[4] Payne JR, Phillips CR (1985). Photochemistry of petroleum. Environ. Sci. Technol., 19: 569-579.
[5] Hussein, M.1, Amer, A. A. and Sawsan, I. I. 2009. Oil spill sorption using carbonized pith bagasse. Application of carbonized pith bagasse as loose fiber. Global NEST Journal, Vol 11, No 4, pp 440-448.
[6] Bolognesi, C., Perrone, E., Roggieri, P., Sciutto, A., 2006. Bioindicators in monitoring long term genotoxic impact of oil spill: Haven case study. Marine Environmental Research 62, S287–S291
International Journal of Science and Engineering Investigations, Volume 2, Issue 16, May 2013 96
www.IJSEI.com Paper ISSN: 2251-8843 ID: 21613-17
[7] Gomez Gesteira, J.L., Dauvin, J.-C., 2005. Impact of the Aegean Sea oil spill on the subtidal fine sand macrobenthic community of the Ares-Betanzos Ria Northwest Spain. Marine Environmental Research 60, 289–316.
[8] Hulathduwa, Y.D., Brown, K.M., 2006. Relative importance of hydrocarbon pollutants, salinity and tidal height in colonization of oyster reefs. Marine Environmental Research 62, 301–314.
[9] Suni, S., Kosunen, A. L., Hautala, M., Pasila, A., Romantschuk, M. (2004). Use of a by-product of peat excavation, cotton grass fibre, as a sorbent for oil-spills. Mar. Pollut. Bull., 49: 916-921.
[10] Hulathduwa, Y.D., Brown, K.M., 2006. Relative importance of hydrocarbon pollutants, salinity and tidal height in colonization of oyster reefs. Marine Environmental Research 62, 301–314.
[11] Chitsan Lin, Yu-Jue Hong, Allen H. Hu. 2010. Using a composite material containing waste tire powder and polypropylene fiber cut end to recover spilled oil. Waste Management 30: 263–267.
[12] John G. Reynolds. Hydrophobic aerogels for oil-spill cleanup? intrinsic absorbing properties. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 2001.
[13] Choi H. and Cloud R.M. 1992. Natural sorbents in oil spill cleanup, Environmental Science and Technology, 26 (4), 772–776.
[14] Johnson, R. F., Manjrekar T.G. and Halligan J.E. (1973) Removal of oil from water surfaces by sorption on unstructured fibers, Environ Sci Technol, 7, 439–43.
[15] Yamamoto, H. (1998) Manufacturing of oil sorbent from heat treated wood fiber and developing new products, Cellulose Commun, 5, 148–151.
[16] Miyata, N. (1999) Oil sorbency of sorbents prepared from Kenaf (Hibiscus cannabinus L.) plants. Sen‘i Gakkaishi, 55, 576 -583.
[17] Choi, H., and Moreau, J. P., "Oil spill sorption behavior of various sorbents studied by sorption capacity measurement and environmental scanning microscope", Microscopy Research and Technique, Vol. 25, No. 5, pp. 447- 455, 1993.
[18] Sayed, S. A, El Sayed, A S and Zayed, A M. 2003. Oil Spill Pollution Treatment by Sorption on Natural Cynanchum Acutum L. Plant. Journal of Applied Sciences & Environmental Management, Vol. 7, No. 2, Dec, 2003, pp. 63-73.
[19] Karan, C. P., Rengasamy and Das, D. 2011. Oil spill cleanup by structured fiber assembly. Indian J. of Fibre & Textil Research. 36: 190-200.
[20] Kopayashi, Y., Massuo, R. and Nishiyama, M, Japan pat, 52,138,081. 1977.
[21] Xiaofeng Huang, Teik-Thy Lim, Proceedings, International Oil Spill Conference, American Petroleum Institute, Washington, USA. 2005.
[22] Keko Hori, Maxima E Flavier, Shigenori Kuga, Thi Bach, Tuyet Lam and Kenje Liyama. J. Wood Sci, 46 (2000) 401.
[23] Hyung-Min Choi, Hyo-Iung Kwon and Jerry P Moreau. Text Res. J., 63 (1993) 211.
[24] Teik-Thye. 2007. Evaluation of kapok (Ceiba pentandra (L.) Gaertn.) as a natural hollow hydrophobic-oleophilic fibrous sorbent for oil spill cleanup. Chemosphere. Volume: 66, Issue: 5, Pages: 955-963.
[25] Choi, H., and Moreau, J.P., "Oil spill sorption behavior of various sorbents studied by sorption capacity measurement and environmental scanning microscope", Microscopy Research and Technique, Vol. 25, No. 5, pp. 447- 455 , 1993.
[26] Sherif, S. Z. Hindi. 2013. Calotropis procera: The miracle shrub in the Arabian Peninsula. International Journal of Science and Engineering Investigations (IJSEI), 2 (16): 10 pp.
[27] W. S. Anthony. 1994. Absorption of oil with cotton products and kenaf. Applied Engineering in Agriculture, 10 (3): 357- 361.
[28] White IC. 2010. Oil spill response-experience, trend and challenges, paper presented at the SPILLCON, 8th International Oil Spill Conference, 15-17 August, 2010, Darwin, Australia.
[29] H. M. Choi, H. J. Kwon, J. P. 1993. Moreau. Cotton Nonwovens as Oil Spill Cleanup Sorbents. Textile Research Journal. 63 (4): 211-218.
[30] Maja, M.R.; Dragen, M.J.; Petar, M.J.; Zoran, P.L., and Helga, T.F., "Recycled wool - based non-woven material as an oil sorbent", Environmental Science and Technology, Vol. 37, No. 5, pp. 1008 - 1012, 2003 .
[31] Cooper D, Keller L (1992). Oil spill sorbent: testing protocol and certification testing program. Proceeding of the 15th AMOP Tech. Sem. Environment Canada, Edmonton, Alberta, pp. 479-497.
[32] Mwaikambo, L.Y., & Ansell, M.P. 2002. Chemical modification of hemp, sisal, and kapok fibers by alkalization. Journal of Applied Polymer Science, 84, 2222-2234.
[33] Chitsan Lin, Yu-Jue Hong, Allen H. Hu. 2010. Using a composite material containing waste tire powder and polypropylene fiber cut end to recover spilled oil. Waste Management 30: 263–267.
[34] K. Obi Reddy, C. Uma Maheswari, D. Jeevan Prasad Reddy, B. R. Guduri & A. Varada Rajulu. 2010. Properties of Ligno-cellulose Ficus Religiosa Leaf Fibers. International Journal of Polymers and Technologies. 2(1).
[35] Jayaramudu, B.R. Gudurib, A. Varada Rajulu. Characterization of new natural cellulosic fabric Grewia tilifolia. Volume 79, Issue 4, 2010, Pages 847–851.

Thank you for copying data from http://www.arastirmax.com