Buradasınız

Feedback Control of Flow Field behind a Square Cylinder with Inline Oscillations

Journal Name:

Publication Year:

Abstract (2. Language): 
Control of vortex shedding from a bluff body and vortex induced vibration is of fundamental interest. In recent years a significant amount of work is going on in different engineering and industrial problem such as offshore exploration, marine hydraulics, MEMS (microelectromechanical systems), electronics cooling etc. The present study reports images and signals recorded in the wake of a square cylinder oscillating in the streamwise direction using PIV and HWA. Wakes of a stationary cylinder, one with forced oscillations at the vortex shedding frequency of a stationary cylinder and the flow field resulting from feedback are compared. In the third experiment, cylinder movement is driven by a hotwire signal with the probe placed in the near wake and, in this respect the wake unsteadiness is fed back to the cylinder motion. The amplitude of cylinder movement is about 13% of the cylinder edge. The interest here is towards active control of the flow field at intermediate Reynolds numbers. Experiments have been conducted at Reynolds numbers of 175 and 355. The feedback loop consists of the hotwire probe, phase shifter available in LabVIEW, a power amplifier and electromagnetic actuators. In the presence of cylinder movement, the instantaneous flow field shows suppression of vortex shedding and reduction in velocity fluctuations. The time averaged flow field shows a reduction in the size of the recirculation region with both forced oscillations and feedback when compared to flow past a stationary cylinder. The drag coefficient of a cylinder with forced oscillations is 8% lower than the stationary, while, with feedback, the reduction is 5%.
110-117

REFERENCES

References: 

[1] Choi, H., Jeon, W.P., and Kim, J., 2008, “Control of flow over a bluff body,” Ann. Rev. Fluid Mech., 40, 113-139.
[2] Dutta, S, Panigrahi, P.K., and Muralidhar, K., 2008, “Experimental investigation of flow past a square cylinder at an angle of incidence,” ASCE, J. Engg. Mechanics, 134, 788-803.
[3] Dutta, S. Panigrahi, P. K., and Muralidhar, K., 2007, “Sensitivity of a square cylinder wake to forced oscillations,” ASME, J. Fluids Engg, 29, 852-870.
[4] Lu, B. and Bragg, M, B, 2002, “Experimental investigation of the wake survey method for a bluff body with a highly turbulent wake”, paper number AIAA 2002-3060, presented at the 20th AIAA Applied Aerodynamics Conference, Missouri, USA.
[5] Pastoor, M., Henning, L., Noack, B. R. and Tadmor, G., 2008, “Feedback shear layer control for bluff body drag reduction,” J. Fluid Mechanics, 608, 161-196.
[6] Zhang, M. M., Zhou, Y. and Cheng L., 2004, “Closed-loop-controlled vortex shedding and vibration of a flexibly supported square cylinder under different schemes,” Phys. Fluids, 16 (5), 1439-1448.
[7] Zhang, M. M., Zhou, Y. and Cheng, L., 2003, “Spring Supported Cylinder Wake Control,” AIAA Journal, 41, 1500-1506.
[8] Zhang, M. M., Zhou, Y. and Cheng L., 2005, “Closed-Loop-Manipulated Wake of a Stationary Square Cylinder,” Expt. Fluids, 39, 75-85.
[9] Roussopoulos K.B. , 1993, “Feedback control of vortex shedding at low Reynolds numbers,” J. Fluid Mech. , 248, 267-296.
[10] Warui, H.M.,and Fujisawa, N., 1996, “ Feedback control of vortex shedding from a circular cylinder by cross-flow cylinder oscillations”, Expt. Fluids, 21, 49-56.
[11] Huang, X.Y., 1996, “ Feedback control of vortex shedding from a circular cylinder,”Expt. Fluids, 20, 218-224.
[12] Beaudoin, J.F., Cadot, O., Aider, J.L., Wesfried, J.E., 2006, “ Drag reduction of a bluff body using adaptive control methods” Phys.fluids, 18, 085107.
[13] Tao, J.S., Huang, X.Y. and Chen W.K. , 1996“ A flow visualization study of feedback control of vortex shedding from a circular cylinder, J. Fluid Mech. , 10, 965-970.

Thank you for copying data from http://www.arastirmax.com