AN ELASTIC STRESS ANALYSIS FOR A POLYMER MATRIX COMPOSITE CANTILEVER BEAM SUBJECTED TO A SINGLE TRANSVERSE FORCE
Journal Name:
- Pamukkale Üniversitesi Mühendislik Bilimleri Dergisi
Keywords (Original Language):
| Author Name | University of Author | Faculty of Author |
|---|---|---|
Abstract (2. Language):
In this study, elasto-plastic stress analysis is carried out in a polymer matrix composite cantilever beam of arbitrary fiber orientation subjected to a single transverse force applied to the free end by using the anisotropic elasticity theory. The residual stress component of ax and yield points are determined for 0°, 30°, 45°, 60° and 90° fiber orientation angles. The yielding begins for 0° and 90° fiber orientation angles at the upper and lower surfaces of the beam at the same distances from the free end. It is seen that the yielding begins for 30°, 45° and 60° fiber orientation angles at the upper surface of the beam. The intensity of the residual stress component of ax is maximum at the upper and lower surfaces of the beam. In this study, the residual stress component of ax obtained for the polymer matrix composite thermoplastic cantilever beam reinforced by reinforced unidirectional fibers is compared with that of the thermoplastic cantilever beam reinforced by woven Cr-Ni steel fibers.
Bookmark/Search this post with
Abstract (Original Language):
Bu çalışmada, serbest ucundan P yüküne maruz tek yönlü fiberlerle takviye edilmiş polimer matriksli kompozit ankastre bir kiriş için anizotrop elastisite teorisi kullanılarak elasto-plastik gerilme analizi yapılmıştır. 0°, 30°, 45°, 60° ve 90° oryantasyon açıları için akma noktaları hesaplanarak ox kalıntı gerilme bileşenleri elde
edilmiştir. Akma, 0° ve 90° oryantasyon açıları için kirişin en alt ve en üst yüzeylerinde aynı anda başlamaktadır. 30°, 45°ve 60° oryantasyon açıları için ise kirişin en üst yüzeyinde akmanın daha önce başladığı görülmüştür. Kirişin en alt ve en üst yüzeylerinde ox kalıntı gerilme bileşeni maksimumdur. Bu çalışmanın sonucunda tek
yönlü fiberlerle takviye edilmiş polimer matriksli kompozit kiriş için elde edilen ox kalıntı gerilme bileşenleri, daha önceki çalışmalarda örgü fiberlerle takviye edilmiş termoplastik matriksli kompozit kiriş için elde edilmiş olan ox kalıntı gerilme bileşenleri ile karşılaştırılmıştır.
FULL TEXT (PDF):
- 3