INVESTIGATIONS ON PRODUCTION PARAMETERS OF
POROUS STAINLESS STEEL SURFACES USED ON FUEL CELLS
Journal Name:
- Gazi Üniversitesi Mühendislik-Mimarlık Fakültesi Dergisi
Keywords (Original Language):
Author Name | University of Author | Faculty of Author |
---|---|---|
Abstract (2. Language):
In this study, porous surfaces made of SS316L spherical stainless steel powder have been produced to be used in
heat exchangers of fuel cells by designing and producing forming die and special punches. Minimum pressure
and temperature levels for compacting have been examined to obtain sufficient bonding between powders and
the substrate. Moreover, surface roughness of the substrate has been increased in order to bond substrate and the
powders. Surface etching techniques have been investigated and minimum surface roughness of the substrates
has been defined. Besides, the effects of temperature and pressure on open porosity have been investigated. The
experiments and the tests showed that 200 MPa compacting pressure, 500°C temperature and Ra=1.7 μm
roughness, on the substrate are enough to realize such surfaces. Under these circumstances 29.6% porosity has
been obtained.
Bookmark/Search this post with
Abstract (Original Language):
Bu çalışmada yakıt hücrelerindeki ısı değiştiricilerinde de kullanılabilmesi düşüncesi ile SS316L küresel
paslanmaz çelik tozlarından, bir alt plaka (yüzey) üzerine tutundurulmuş gözenekli yüzeye sahip parçalar
üretilmiştir. Bu tür yüzeylerin üretiminde en düşük basınç-sıcaklık değerleri ile tozlar ve alt plaka arasındaki
ilişki incelenmiştir. Ayrıca; tozların alt tabakaya tutunabilmesi maksadıyla alt tabakanın yüzey pürüzlülüğünün
arttırılması için bir yöntem geliştirilmiştir. Bu amaçla yüzey aşındırma teknikleri araştırılmış, tozların
tutunabilmesi için plakadaki gerekli en düşük yüzey pürüzlülüğü değeri belirlenmiştir. Çalışmalar yapılırken
işlemin sanayideki uygulanabilirliği gözetilmiştir. Bunun yanında sıcaklık ve basıncın, açık gözeneklilik
üzerindeki etkisi araştırılmıştır. Yapılan deney ve testler 200 MPa presleme basıncı, 500°C presleme sıcaklığı,
Ra=1,7 μm plaka yüzey pürüzlülüğü ile gözenekliliğin %29,6 olarak ölçüldüğü değerlerin, bu tip yüzeylerin
üretimi için yeterli başlangıç koşulları olduğunu göstermiştir.
FULL TEXT (PDF):
- 2